Omada Controller
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada Controller
hi. i've been trying to sort this out but not sure what is happening
i wanted to know which port from the switch the ap is connected so checked the topology.
i can confirm that both the ap is running through wired. mesh is disabled.
but if u see below, the family area doesnt show which port it is connected to but instead showing it goes through dining area? and it doesnt show which port it is connected to the switch.
could anyone tell me what i'm doing wrong.
please and thank you
1 Accepted Solution
Re:Omada Controller-Solution
Have you turned on LLDP? If not, kindly try turning it on. Besides, you can try to reboot the network to check if that would help.
Best Regards!
>> Omada EAP Firmware Trial Available Here <<
>> Get the Latest Omada SDN Controller Releases Here <<
*Try filtering posts on each forum by Label of [Early Access]*
Re:Omada Controller-Solution
Have you turned on LLDP? If not, kindly try turning it on. Besides, you can try to reboot the network to check if that would help.
Best Regards!
>> Omada EAP Firmware Trial Available Here <<
>> Get the Latest Omada SDN Controller Releases Here <<
*Try filtering posts on each forum by Label of [Early Access]*