Home

Forums

Stories

Knowledge Base

Business Community > Pharos Wireless Bridges > Connect a security camera to CPE

< Pharos Wireless Bridges

Connect a security camera to CPE

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Connect a security camera to CPE

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

captainwoody

2024-06-26 18:56:19

Posts: 2

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2021-06-28

Connect a security camera to CPE

2024-06-26 18:56:19

Model: CPE210

Hardware Version:

Firmware Version:

Can I connect a security camera directly to the lan port on a client side CPE210 power supply?

The camera has it's own poe power supply so I would connect the lan ports together. Or is a switch required?

I recently patched into a Ubiquiti dish on a work site and it allowed direct lan plug in without a switch.

Needing to add a switch to an outside installation would be unfortunate.

2 Reply

Hank21

2024-06-27 09:08:29

Posts: 3673

Helpful: 721

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:Connect a security camera to CPE

2024-06-27 09:08:29

@captainwoody

Do you install two CPEs?The client side CPE adapter cannot be used to power your security camera; but, if you connect the camera to the LAN port, it will give internet access.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

captainwoody

LV1

2024-06-27 19:16:12

Posts: 2

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2021-06-28

Re:Connect a security camera to CPE

2024-06-27 19:16:12

I tested it. A cpe210 AP to a cpe210 Client was able to run a Lorex camera (using it's own poe) without a switch. Great.

Connect a security camera to CPE

Connect a security camera to CPE

Information

Voters 0

Tags