How to upgrade OC 200 controller version to 5.13?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to upgrade the controller software. I'm not asking about the firmware.
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Is it not successfully upgrading itself? Mine took the 5.13 load via the Controller UI just fine.
I strongly recommend you make a backup before starting though! At least you can do a manual factory reset and reload that way.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Errefae
I have the latest firmware already. But i tried and re-installed it manually. it didn't upgrade the controller version. still stuck at 5.12.9
- Copy Link
- Report Inappropriate Content
If the upgrade won't take from the unzpped .bin file, then try downgrading to 5.9 first and then go direct to 5.13. Again, take a backup at each step just in case.
- Copy Link
- Report Inappropriate Content
Just a copy:
You may follow the guide below to upgrade or downgrade your Omada Controller.
How to Upgrade or Downgrade Omada SDN Controller
Note: for the sake of insurance, it's always recommended to save a copy of the controller Backup Config file before upgrade or downgrade.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 729
Replies: 7
Voters 0
No one has voted for it yet.