ER605 frequently disconnects from OC200 after upgrading to firmware 2.2.0
Hi,
My ER605 disconnects from OC200 controller frequently(every couple of hours) after upgrading to the latest 2.2.0 firmware. However, the internet is still functioning in this case even OC200 controller shows as disconnect. I had to power cycle the router for the OC200 controller to re-adopt back into the system. My OC200 hardware is v1.0 and OC200 firmware is 1.24.0 build 20230328 rel 52384.
If I revert back to ER605 firmware to earlier version of 2.1.2build 20230221(beta), the disconnect issues goes away. Is there a workaround to resolve this issue instead of having to power cycle the router after every few hours. If not, I guess I have to downgrade my system to the previous stable version.
Thanks.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Please roll back your ER605 firmware. You can find the firmware here.
For each release, the firmware will adapt to a version of the controller. We suspect that may be related to compatibility.
Refer to the solution thread as well: Solution to ER605 V2 2.2.0 Firmware Frequently Disconnects From Omada Controller V5.9
- Copy Link
- Report Inappropriate Content
Hi All,
A newer 2.1.4 Beta firmware has been released for trial, please follow the post link below for details.
ER605 V2_2.1.4_Build 20230720 Beta Firmware For Trial (Released on July 21st, 2023)
- Copy Link
- Report Inappropriate Content
+1 same issue
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Raytsh same here disconnects and then never reconnects. Had a long period of stability with previous beta firmware and now back to disconnecting
- Copy Link
- Report Inappropriate Content
Happening the same with my router after upgrade. A lot of notification in my mobile APP
- Copy Link
- Report Inappropriate Content
Errors:
- Copy Link
- Report Inappropriate Content
Hello together.
I have the same issue after upgrade from 2.1.2 to 2.2.0.
With the Beta 2.1.2 all was fine.
Greetings, Totti
- Copy Link
- Report Inappropriate Content
+1 beta no problem, 2.2 0 broken again... FFS how hard is this to get right???
- Copy Link
- Report Inappropriate Content
are you using your WAN as pppoe and your modem is adsl?
i am reading posts from last week and there were reports on this earlier last week. people said they were using pppoe and experienced this.
- Copy Link
- Report Inappropriate Content
are you using your WAN as pppoe and your modem is adsl?
i am reading posts from last week and there were reports on this earlier last week. people said they were using pppoe and experienced this.
- Copy Link
- Report Inappropriate Content
Hi @Raytsh @NEO-KUBERA @DPlus @Totti_14 @Tescophil @Tedd404
Thank you so much for your invaluable feedback. We greatly appreciate your input. I have forwarded the issue to our support engineers for further investigation and will try to provide an update here when there is any progress.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 5
Views: 4226
Replies: 32