Best Settings for EAP225 in residential application
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello everyone.
Until now my EAP225s have worked flawlessly. This past week my home was part of the large Summit outages. Since then I am encountering speed issues.
My current system is as follows.
I have a 2 floor home, each floor has a ceiling mounted EAP225. Both have (2) SSIDs. (1) at 2.4Ghz and (1) at 5Ghz. Those names are matched on both floors.
I have the 2.4ghz set to channels to help with the traffic from neighbors Wifi, and my 5G network is set to auto.
Hardwired I am always in the 500 up and down range at the lowest but average about 800 on a 1G service.
Since the outage my speed has improved at my hardwired station but at most I get 75 on 2.4 and 400 on 5g.
Is there any recommendations anyone could share?
2.4GHZ setup
Channel Width
20/40Mhz
Tx Power
High
5Ghz
Channel Width
20/40/80Mhz
Tx power
High
