Low performance on wireless bridge with two CPE710 (AP + Client)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Low performance on wireless bridge with two CPE710 (AP + Client)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Low performance on wireless bridge with two CPE710 (AP + Client)
Low performance on wireless bridge with two CPE710 (AP + Client)
2023-01-28 18:01:24
Model: CPE710  
Hardware Version: V1
Firmware Version: 2.3.0 Build 20211216

Hi all, after configuring two CPE710 (AP + Client) 200 meters apart, I am experiencing low performance. The devices are matched to 866Mbps RX/TX Rate and are connected to Full-Duplex gigabit ethernet. If I try to transfer an ISO file from one end to the other, I get around 200Mbps. Anyone else in the same situation? Any suggestions?

  0      
  0      
#1
Options
1 Reply
Re:Low performance on wireless bridge with two CPE710 (AP + Client)
2023-02-01 12:23:13 - last edited 2023-02-01 12:27:29

  @francesc1 I have been using CPE710s for a few years but with shorter range and excellent connection. They also show full speed link. I used the speed test built into the CPEs and the most I could get was around 400Mbps at about 200 feet. Also set up at 600 feet in case distance was too short but performance dropped as distance increased, again with the units showing full speed link. So my conclusion on these units is they will not deliver to spec. I would expect half of what they claim at best.

 

I replaced them with Ubiquiti GigaBeam | airMAX AC 60. Cost is MUCH greater, but so is performance. They delivered to full spec and I get over 100MBs  down/ up at a little over 200 feet.

  1  
  1  
#2
Options