VLAN on ETH2

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

VLAN on ETH2

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
VLAN on ETH2
VLAN on ETH2
2022-05-16 21:12:41 - last edited 2022-05-17 02:21:02
Model: EAP245  
Hardware Version: V3
Firmware Version: 5.0.0 Build 20200918 Rel. 61625(5553)

Where do I find the VLAN setting for the ETH2 port?

  0      
  0      
#1
Options
1 Accepted Solution
Re:VLAN on ETH2-Solution
2022-05-16 21:34:49 - last edited 2022-05-17 02:21:02

  @SaiGer 

 

As far I know is not possible, is just like a bridge for mgmt or native vlan.

If you want to set the vlan for eth port you should have to use EAP235/615 wall plate.

 

Best Regards

Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:VLAN on ETH2-Solution
2022-05-16 21:34:49 - last edited 2022-05-17 02:21:02

  @SaiGer 

 

As far I know is not possible, is just like a bridge for mgmt or native vlan.

If you want to set the vlan for eth port you should have to use EAP235/615 wall plate.

 

Best Regards

Recommended Solution
  0  
  0  
#2
Options
Re:VLAN on ETH2
2022-05-17 12:27:41

I posted the question on Amazon and I got this response:

 

"Yes this access point supports vlan. You configure it through the access point management interface or using tplink Omaha controller software. You will need a separate router/firewall to make the vlan work."

 

I set the vlan id to 1 on the management interface and it did not work. Devices connected to the ETH2 do not get an IP from the router.

 

Any idea what that setting is for?

  0  
  0  
#3
Options