Persistent client connection in client list
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Persistent client connection in client list
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Since the ER605 was updated to firmware 1.2.0 When clients leave the wifi area and disconnect from wifi, or if a wired connected computer attached to one of my TL-SG2008 is turned off. In the cloud managed client list tab for the site, or in the site map tab. The disconnected clients will now continue to be shown, but they will now be shown connected directly to the ER605, instead of the wireless access point or ethernet switch that they were connected to before they were turned off. Even wireless devices that are turned off or move out of wireless range will now be shown as wired to the ER605 in the site map or in the client list. They will continue to be shown as attached to the ER605 even though they have been disconnected or turned off. When they reconnect to wifi, or are turned back on they will be shown correctly attached to the access point or switch that they are actually attached to.
This didnt happen before, but has been happening since the update to version 1.2.0
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @loafingshed,
Regarding the issue of persistent client connection in client list reported here, the 1.2.1 firmware has done some optimization to improve it, you may install the firmware provided in this post and confirm whether the issue still exists. If the issue is resolved, I'd encourage you to update this topic thread so that others may benefit from it.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1691
Replies: 11
Voters 0
No one has voted for it yet.