Home

Forums

Stories

Knowledge Base

Business Community > WiFi > EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?

< WiFi

EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

SuperCoolYolo

2021-12-07 17:53:53 - last edited 2021-12-08 14:26:37

Posts: 3

Helpful: 5

Solutions: 0

Stories: 0

Registered: 2021-12-07

EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?

2021-12-07 17:53:53 - last edited 2021-12-08 14:26:37

Model: EAP245

Hardware Version: V3

Firmware Version: 5.0.1

Hi there,

I'm using several EAP245 access points with the Omada software controller v4.4.6.

Previously I was able to setup all the AP's in standalone mode and I can remove wireless B and G from the 2.4Ghz band. I'd like to do the same using the Omada controller for all the AP's but there doesn't seem to be a way to do it. I can enable 2.4Ghz or 5Ghz but I can't set anything more specific.

Is it not supported with the Omada software controller? Or did I miss something?

Appreciate any help anyone can provide.

Thank you!

1 Accepted Solution

Virgo

LV5

2021-12-08 07:46:21 - last edited 2021-12-08 14:26:37

Posts: 2588

Helpful: 347

Solutions: 191

Stories: 0

Registered: 2021-05-10

Re:EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?-Solution

2021-12-08 07:46:21 - last edited 2021-12-08 14:26:37

@SuperCoolYolo

I guess this below things that you said, right?

Just striving to develop myself while helping others.

Recommended Solution

SuperCoolYolo

LV1

2021-12-08 14:26:31

Posts: 3

Helpful: 5

Solutions: 0

Stories: 0

Registered: 2021-12-07

Re:EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?

2021-12-08 14:26:31

@Virgo

Thanks for your response Virgo. I believe you are correct, that was the setting that should help me achieve my goal of preventing clients from connecting on wireless B and G modes.

It's unfortunate that the setting is hidden under those configuration options. It is not easily visible. I hope TP-Link can change the UI to make it more clear.

Again, thank you for your help!

EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?

EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?

Information

Voters 0

Tags