Omada OC200 connection type constant switching
Omada OC200 connection type constant switching
![](/avatar/avatar-11.png)
Hello,
last week I updated the firmware on the OC200. Yesterday I found out that wifi clients are incorrectly detected. They randomly switch WiFi clients from Wifi to LAN.
All network devices has updated, no have VLANs.
My network contains:
Omada OC200 controller version 4.2.8, fw 1.7.3 Build 20201119 Rel.63433
TL-R605 router V1 fw 1.0.0 Build 20200930 Rel.36519
TL-SG108E switch fw 1.0.0 Build 20181120 Rel.40749
1x EAP245 V3 fw 5.0.0 Build 20200918 Rel. 61625
1x EAP 225 outdoor V1 fw 5.0.0 Build 20200918 Rel. 58628
I tryed:
- Omada OC200 reset and restore older cfg
- readopting all devices
How do I fix this?
Thank you very much,
Pavel
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
![](/avatar/avatar-19.png)
Hi All,
As an update, the "Wireless Clients showing as Wired in SDN" problem has been fixed in the Omada SDN Controller v4.2.11 already.
If you have any further issues/concerns, please feel free to start a new thread on the community.
BTW, the thread below will be updated once there is new firmware released in the future, welcome to subscribe to it.
【Update 3/4/2021】Latest firmware released for Omada SDN Controller v4.2.11
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I may have to replace the older switch with this omada supported TL-SG2008P
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@PavelV I have same problem after upgrade. Switching from AP to LAN after 5 minutes. I dont know why :(. I have three networks with OC200. But i have this error only in network with TL-R605 router
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi Zdeňku, where is it possible to get this log?
- Copy Link
- Report Inappropriate Content
@PavelV hi. It's in Log/Event
- Copy Link
- Report Inappropriate Content
Thank you, in my log is "logged in to the controller" and once "EAP245_1.patro was readopted automatically, EAP225_zahrada was readopted automatically, TP Link TL-R605 was readopted automatically.
- Copy Link
- Report Inappropriate Content
I have the same problem, without the Omada OC200.
Wifi clients are registered as a wired clients.
- Copy Link
- Report Inappropriate Content
Hello,
I compared your Omada_Controller_V4.2.8_Windows, in my Omada OC200 is the same version.
It may contain an error.
- Copy Link
- Report Inappropriate Content
![](/avatar/avatar-11.png)
Information
Helpful: 0
Views: 4557
Replies: 16
Voters 0
No one has voted for it yet.