Trying to upgrade OC200 to SDN
Hello. Trying to ugprade my OC200 to SDN but when I try to upgrade the firmware it says it is already up to date. Currently running 1.2.3 Build 20200430 Rel.52621.
Perhaps I am too early and jumping the gun and OC200 is not ready for upgrade yet. If so perhaps I can instead export my config from OC200, install windows controller and then restore the config to the windows controller. Would that work or no?
Willing to run the OC200 beta as well if it is available.
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@ctem81 It's showing up in my oc200 as of this morning.
- Copy Link
- Report Inappropriate Content
@mackworth Yup I see it as well. Thanks for letting me know. Funny thing is the IOS app showed my firmware as being up to date. I had to login via web interface gui in order to see that the update was available.
- Copy Link
- Report Inappropriate Content
Just upgraded without trouble. Backed up existing controller config, ran firmware upgrade, skipped through setup wizard after controller came back up and restored the backed up config. At that point I saw my 4 access points showing. Only catch was the controller did not allow me to upgrade them automatically. I had to manually upload and upgrade the firmware for each AP one at a time. After they were upgraded all is looking good.
- Copy Link
- Report Inappropriate Content
Interesting. If i want to upgrade my OC200 i receive an general error. Yesterdays-Upgrade-Check says the OC200 Firmware is up to date...
- Copy Link
- Report Inappropriate Content
@Nemesis did you try via full web interface and not via mobile app?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 2044
Replies: 7