Advice sought by newbie on setting up CPE210 and IP/Wifi camera

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Advice sought by newbie on setting up CPE210 and IP/Wifi camera

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

grayb

2020-02-18 17:44:22 - last edited 2020-02-20 07:38:23

Posts: 9

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-02-18

Advice sought by newbie on setting up CPE210 and IP/Wifi camera

2020-02-18 17:44:22 - last edited 2020-02-20 07:38:23

Model: CPE210

Hardware Version:

Firmware Version:

Advice sought by newbie on setting up CPE210 and IP/Wifi camera.

I have set up CPE210, one as an AP (to computer via router), the other as Client (to cctv camera).

All LED's on both CPE210's are OK, and signal strength full.

1 - However when going into PharOS it says that the client is disabled ?? any ideas.

2 - Antenna distance has been set to 1km. Can this be causing an overload if distance for testing is 50m.

Many thanks

1 Reply

R1D2

LV6

2020-02-20 14:08:28 - last edited 2020-02-20 14:09:04

Posts: 4334

Helpful: 1039

Solutions: 173

Stories: 3

Registered: 2015-12-05

Re:Advice sought by newbie on setting up CPE210 and IP/Wifi camera

2020-02-20 14:08:28 - last edited 2020-02-20 14:09:04

@grayb, you should set »Distance« setting to either »Auto« or to the actual distance. Also make sure the CPEs are carefully aligned to each other, this is important for directional links.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻

Advice sought by newbie on setting up CPE210 and IP/Wifi camera

Advice sought by newbie on setting up CPE210 and IP/Wifi camera

Information

Voters 0

Tags