@plavielle 

After 10 days of working, i've disconnection or it is impossible to connect without reboot or phisically disconnect AP.

Do you mean after you upgrade the firmware, your clients have disconnection issue when they connect to this AP? We think it maybe not related to the firmware. We recommend you to disable Band Steering, Load Balance, Airtime Fairness. Then change the channle to have a try.

Another problem was that, on one AP i cannot downgrade firmware (i tested on 3 only 2 was ok).

Do you mean you try to downgrade the firmware three times and only two times succeed? We recommend you to change another browser and try. 

forrest wrote

@plavielle 

 

After 10 days of working, i've disconnection or it is impossible to connect without reboot or phisically disconnect AP.

Do you mean after you upgrade the firmware, your clients have disconnection issue when they connect to this AP? We think it maybe not related to the firmware. We recommend you to disable Band Steering, Load Balance, Airtime Fairness. Then change the channle to have a try.

 

 

Another problem was that, on one AP i cannot downgrade firmware (i tested on 3 only 2 was ok).

Do you mean you try to downgrade the firmware three times and only two times succeed? We recommend you to change another browser and try. 

@forres

First, after upgrade from 1.6.0 to 1.6.1 EAP225-outdoor, there is connection problem : with 1.6.0 no problem reported, with 1.6.1 : disconnection. I'm going to disable what you said. But all the AP was managed by an OC200.

Seconf : on 3 different EAP225-outdoor, i've made a firmware downgrade. On one it's impossible of downgrade (file not checked or verify). I've tested on different browsers and the same result.

plavielle wrote

 Seconf : on 3 different EAP225-outdoor, i've made a firmware downgrade. On one it's impossible of downgrade (file not checked or verify). I've tested on different browsers and the same result.

We make a limitation on the firmware 1.6.1. That is, when we upgrade to this version of firmware from 2018 or older version, we cannot downgrade to the older version again. If we upgrade to the latest firmware from firmware 1.6.0, we should be able to downgrade to the older firmware. We also notice this in the release note of EAP.

But we don't recommend you to downgrade the firmware, normally we will fix some bugs and add some new features in the new firmware, so we recommend you to use the latest firmware. And if you meet any issue when you use the new firmware, we will try to help you.