Hi...I am using TL-R470T+ for Failover and combine bandwitdh from Two WAN.

But it seems neither of the function works.

Both my modem works well if were used alone.

 

My setup:

WAN 1 as Primary, ISP 4G Modem, metered connection, if the usage hit the limit, internet cannot connect at all, browser shows no connection.

WAN 2 as Backup, ISP 4G Modem.

 

CURRENT SETTING:

 

Status >> Traffic Statistics shows WAN 1 (Link Up) and WAN 2 (Link Down)

 

Network >> WAN 1 and WAN 2

Network >> WAN 1 has dynamic ip with certain ip adress and connection status "connected"

Network >> WAN 2 has dynamic ip with ip adress 0.0.0.0 and connection status "disconnected"

 

Transmission >> Load Balancing is enable

Transmission >> Load Balancing >> Link backup...WAN 1 as primary, if fail use WAN 2

Transmission >> Load Balancing >> Online Detection all use auto, but WAN 1 shows ONline, but WAN 2 shows OFFline

 

Question:

1. How can I manage the Fail Over properly.

What happened was WAN 1 had reach metered limit, it cannot switch to WAN 2.

WAN 2 can only function if I shutdown/disconnect WAN 1 (primary)

 

2. How to set WAN 2 (backup) support WAN 1 (primary) if the bandwitdh do not reach the minimum limit?

Lets say I wish to have minimum 10 Mbps, If WAN 1 (primary) is slow, then WAN 2 come to help.

 

 

Thanks