It would be really nice to know what is connected on the downlink specially if you have multiple switches hanging off the router.

Does the ER8411 support subinterface? My L3 switch doesn't support dhcp server only relay, the L2 switch I have in the network does support dhcp server but when there is a load it just locks up the...

I searched high and low in the CLI and in the WebGUI, but this is something that all basic managed switch should have. Show me the known MAC table. (there is a CLI 'show arp' but not 'show mac'?) If...

@Clive_A I am not explaining your case but what you described in the OP that "Multi-Net NAT" is missing. My point is to explain that is NOT missing. You might not use the title like that. Like the...

@Clive_A I read the thread you showed... but that is EXACTLY NOT what I want to do. If you set the router with all the SVI table the router will be the one doing inter-vlan routing/switching.. which...

this should be a pretty simple thing. I have Adguard DNS service. They assigned me to use two specific DNS server that support DoT. I go into the ER8411 and added the two IP address in the DoT tab. I...