Chris.A.G wrote Base ap previously fed 3 APs, with -72 to -77 db connection strenths the weakest of which resulted in TX of around 117mbps , RX of between 117-234mbps -72dBm to -77dBm is not a...

Q.E.D.: It didn't take long for another TP-Link customer to request that a portal with voucher authentication be split over two separate SSIDs:...

@ATPackaging, what protocol did you specify for the ACL rule with ID #2 (if any)?

@texas46rv, perform a hard reset on the fourth AP to load factory defaults (press the RESET button and hold it for ~7 seconds until the LED flashes green-yellow-red) and try again to adopt it. You...

@CHASER, CPEs are for long-range directional links, they use directional antennas and usually are used pair-wise, while EAP110 uses omnidirectional antennas, which have a much smaller range, but a...

JSchnee21 wrote 2) I'm not sure if this is possible, but see if you can create two separate profiles (e.g. off1 and off2), each with one rule, and associate both with the AP. IIRC, there can be only...