JL2018 wrote Model : Hardware Version : Firmware Version : ISP : Please advise how to enable IGMP Snooping over 1) LACP 2) Stacked switches you can check FAQ from TP-LINK, as IGMP snooping, you can...

JL2018 wrote Model : Hardware Version : Firmware Version : ISP : If Jumbo frames support is enabled in the T170028TQ for ports in members of a stacked switch, please advise if the ports bonded should...

Ventoux wrote Model : Hardware Version : Firmware Version : ISP : I'm unable to connect to the WEB GUI of my T1600G-28PS Switch. Tried using 192.168.0.1 as directed in the manual & all I get is:...

politgem wrote Model : Hardware Version : Firmware Version : ISP : My TP Link TL-SF1048 48 ports 10/100MBPS Switch suddenly stopped blinking, but the power is on...... Please I need assistance Thank...

Drocona wrote Hi TPTHZ, Thanks for the suggestions, my vSphere environment was set up correctly. I figured out what the problem was, however I have no clue why this was happening. Instead of Admin...

Due to computer connect to the port 1/0/12, this port belongs to vlan3. But you only configured ip address for vlan1(go to Routing--->Interface). So this computer can not access switch via ip address...