I reset the router/gateway and used an old linksys 54g router to plug the client into and it was up and running. Since it was working I switched to my wired router that I use for my main router to...

I wanted to get the right cable, I only found 1 cable that says shielded and grounded:...

There's a long list of devices on the modem main page but most are offline, there's a button to clear list and another for scan for devices. It is DHCP enabled. Maybe I have too many with all the...

Model : Hardware Version : Firmware Version : ISP : So I have a DSL modem from Frontier. (Arris NVG448BQ) 4 lan ports Port 3 ------ CPE210 AP ))) ((( wireless extender/ wireless users Working fine....

My thought was the broadcast that goes past the destination wouldn't be picked up by anyone if it didn't go so far. But I went ahead and enabled security. Now I'm going to spend more on a 50' cable...

Seems like your first setup should work. Are you just networking these computers or are you sending the internet out to the client 510 also? Bridge mode would be used to bridge between two networks...