@cmcouwenb I am having the same issue, nothing to do with changing port, I installed the 5.8.4 update and when Omada started I am missing all the data, all I have is 3 tabs on the side. I have no...

@PatrickMcC So I finally got this working. Below is what I did: After login as admin, type "enable" without the quotes, hit enter, type "configure" without quotes, hit enter, type "interface...

@PatrickMcC Thank you so much, I will try this tomorrow when I am back with the switch. Patrick

@PatrickMcC I was able to login using the CLI but I don't know the command to do it. I tried following the guide to change it, but I get Bad Command error. This is what I entered: Switch (config)#...

Hi all, so I just received the TL-SX3008F smart switch which has 8 SPF+ 10gbe ports. It seems from research that this switch will not be detected by Omada unless one of the ports is set to 1gbe. At...

Hi all, simple question, if I am moving the Omada Software from a Docker where it is currently running and set it up on a standalone PC, should I disconnect all the Omada controlled switches first?...