ingeborgdotLV2Online
Following: 0Followers: 0
Forums/ Controllers
2022-06-07 12:34:47
Re:OC200 controller went offline and has now been off for 24 hours
I had 4 new alerts this morning, 4 is good compared to 54 and totally going offline for 24 hours. Looking at the content, it started with the Hallway EAP, then 9 seconds later, the office switch...
0HELPFULS
Forums/ Controllers
2022-06-06 12:20:02
Re:OC200 controller went offline and has now been off for 24 hours
@Virgo I was down at the time, and couldn't find the info. Here it is. Router - ER605 V2.0 - 2.0.1 Build 20220223 Rel.68551 Switch - TL-SG2210P v3.20 - 3.20.2 Build 20210806 Rel.55686 EAP - EAP245...
0HELPFULS
Forums/ Controllers
2022-06-05 16:26:16
Re:OC200 controller went offline and has now been off for 24 hours
I will let you know my Omada System setup so it may make more sense. In my Office, is where my cable comes in for the cable modem. I have it attached to the ER605 and then run it into my Office...
0HELPFULS
Forums/ Controllers
2022-06-05 15:10:59
OC200 controller went offline and has now been off for 24 hours
My OC200 went on and offline continuously yesterday and then went offline and has not come back on for over 24 hours. What do I need to do to figure out why?
0HELPFULS
Forums/ Controllers
2022-05-25 21:42:08
Re:Should I use 443 or 8043?
@JFND Okay, I see. For the hardware controller it shows 443, and for the software controller it shows 8043. Thanks.
0HELPFULS
Forums/ Controllers
2022-05-25 12:26:58
Should I use 443 or 8043?
In the OC200 controller GUI, there is an Access Config section that has Hostname/IP, HTTPS Port For Controller and other things. I was just looking at some things on the TP Link site, and found a...
0HELPFULS
12345...