Hi @Hank21 This may be a long list but here it goes. Where: Navbar Why: Dark Mode Toggle, bit hard to go from global to site each time. How to improve: Add a little toggle on the navbar for...

using WAN using WAN/LAN1 weird or it auto redirect?

Hello @Hank21, This is the firmware OC300v1_un_1.17.0_20230328_rel52369_up.bin Link backup is not enabled. i have a 1:1 load balancing. This is the routing policy. This was working before the update...

Hello, I encounter some difficulties and problem after i update to 5.9.32 . Some configuration are not working and the ER7206 showing disconnected after a long time. I did some troubleshooting and...

Hi, I would like to seek some help regarding site-to-site vpn using a dual wan setup, i cannot find any documentation and im not sure if i am correct. I already have a site-to-site setup but i am...

@PatrickMcC Sorry i cannot give you the specific syntax, but you can try Switch#configure Switch(config)#interface gigabitEthernet 1/0/1 <--replace it with your port Switch(config-if)#speed 1000...