I have narrowed it down to LLDP. Enabling it on AP port profiles breaks the VLAN's which in turn stops the WiFi from working.Tested with the controller and in the standalone mode. This works but as...

Anyway to get LAG (LACP) working between ER7206 (Port 4 & Port 5) <> TL-SG2008P (Port 7 & Port 8). I was able to setup a static LAG but can't get LACP working in standalone mode(Active or Passive).

That didn't work in the cloud interface. But I just reset my ER7206 and TL-SG2008P to standalone mode.Both the access points worked out-of-the box without making any changes. Also it's so much easier...

I think the switch is stripping tags from VLAN1 traffic as the AP's use tagged VLAN1. Any workaround so that the switch leaves tagged VLAN1 traffic as it is instead of treating all traffic on VLAN 1...

@Fae Currently only 1 AP is connected as the other one is connected through the ISP router so I can have internet access. The AP250 radios are turned off if no internet connection is detected on eth0...