Thanks. Yes I see there's room for improvement on WiFi in general then. It's time for "smart-WiFi" ;-) In theory: If client devices keep notifications off or with a certain time interval (remember:...

@Philbert Thanks, I've contacted TPlink for a standby mode, as currently this is not available (but they will send it as a request to consider by R&D). I was hoping the "energy saving mode" would...

Thanks, Too bad there's no WiFi standby modus; was hoping for such. And beacon interval is limited to 100ms, was hoping to delay it even more.

@ballibeg Just make sure the AP doesn't use DHCP then since otherwise it would have received a dynamic IP address in that range in the first place (being a client of the network, receiving the IP...

Not sure but some ideas... - I suppose you connected via (PoE ) cable and using the correct port on the EAP115? - Have you used the app to configure things correctly? - If you have both your ISP...

@Jrob147 Hi, I believe you will need to have this one in the wall, connected to an ethernet cable, running through PoE. Most likely the other end will need a PoE solution like a switch or a port...