Weird problem with two EAP110
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Weird problem with two EAP110
Model :
Hardware Version :
Firmware Version :
ISP :
Model: EAP110
HW ver.: V1
FW ver.: EAP110(EU)_V1_160405
Hello all, i need your help for a strange issue that i have with two identical devices, two EAP110. I updated them to the latest firmware when i pulled them out of the box, then i have configured the first one with a static IP (192.168.1.2) and a SSID with a password with a output power of 26 dBm. Ok, that's what I want. So i want to configure the second one. And the troubles begins... It does not permit to change the output power, it hangs to 20 dBm maximum, and (most important) it does not permit me to change the IP to static (192.168.1.3) instead of dynamic, every time i try to, with a reboot too, even the interface seems to get te IP that I assign to it correctly (i verify it with tools like Fing), browser can not access to AP, and gives me "connection refused" error. Why AP gives me back these errors? why i cannot access? There is some setting that i can give to set the output power to more than 20 dBm, like the first one? I think that i give the same settings to both of them. I hope that someone can help me.
Sorry for my bad english, and thanks to you all!!
jerrino77
Hardware Version :
Firmware Version :
ISP :
Model: EAP110
HW ver.: V1
FW ver.: EAP110(EU)_V1_160405
Hello all, i need your help for a strange issue that i have with two identical devices, two EAP110. I updated them to the latest firmware when i pulled them out of the box, then i have configured the first one with a static IP (192.168.1.2) and a SSID with a password with a output power of 26 dBm. Ok, that's what I want. So i want to configure the second one. And the troubles begins... It does not permit to change the output power, it hangs to 20 dBm maximum, and (most important) it does not permit me to change the IP to static (192.168.1.3) instead of dynamic, every time i try to, with a reboot too, even the interface seems to get te IP that I assign to it correctly (i verify it with tools like Fing), browser can not access to AP, and gives me "connection refused" error. Why AP gives me back these errors? why i cannot access? There is some setting that i can give to set the output power to more than 20 dBm, like the first one? I think that i give the same settings to both of them. I hope that someone can help me.
Sorry for my bad english, and thanks to you all!!
jerrino77
