EAP 110 - cant adopt Access Points from Management console
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP 110 - cant adopt Access Points from Management console
Model :
Hardware Version :
Firmware Version :
ISP :
We have bought 4 access point EAP110 ad wanted to have tem under the same SSID. All Access points have been connected to the same router in the same network. After EAP manger was installed it picked one AP as a master AP. I than tried t find the others AP's but couldn't. I was browsing the tlink forum and came across some info to update the firmware which I did. After restarting the PC and the router I could see finally all AP's appearing. I tried then to adopt them to the master and the request timed out.
I tried several different options, First to connect to a switch before I connect them to our router. If I check on the router web interface The MAC addresses of all the AP's show as unknown device.
In the forum I could no find any other problem like this. I would appreciate if someone can help me out with this.
Thanks in advance
Hardware Version :
Firmware Version :
ISP :
We have bought 4 access point EAP110 ad wanted to have tem under the same SSID. All Access points have been connected to the same router in the same network. After EAP manger was installed it picked one AP as a master AP. I than tried t find the others AP's but couldn't. I was browsing the tlink forum and came across some info to update the firmware which I did. After restarting the PC and the router I could see finally all AP's appearing. I tried then to adopt them to the master and the request timed out.
I tried several different options, First to connect to a switch before I connect them to our router. If I check on the router web interface The MAC addresses of all the AP's show as unknown device.
In the forum I could no find any other problem like this. I would appreciate if someone can help me out with this.
Thanks in advance
