Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

Hi, maybe I'm doing something wrong (or missing something)

Model: TL-ER5120
Firmware Version: 1.0.8 Build 20140212 Rel:36037
Hardware Version: TL-ER5120 v2.0

I have two ISP: ISP1 on WAN1 and ISP2 on WAN2
Port 5 is connected to the LAN switch.
All PC have static IP.
I want to allow 1 particular IP (192.168.0.53) to navigate over WAN2 and the rest of network through WAN1
I followed instructions from FAQ but I couldn't get this working

I've set
Network -> System Mode: NAT
Advanced -> Load Balance: Enable Application Optimized Routing: checked
Advanced -> Load Balance: Enable Bandwidth Based Balance Routing: checked
both WAN ports checked

Also, in Advanced -> Load Balance -> Policy Routing I made two rules:
Rule1
Source IP 192.168.0.53 - 192.168.0.53
Destination IP 0.0.0.0 - 0.0.0.0
Ports --
Protocol: All protocols
WAN: WAN2

Rule2
Source IP 192.168.0.1 - 192.168.0.254
Destination IP 0.0.0.0 - 0.0.0.0
Ports --
Protocol: All protocols
WAN: WAN1
to ensure rest of network will use WAN1

So (if my logic works) if IP 192.168.0.53 wants to navigate, would do using WAN2, and the rest would do on WAN1.
But this is not working. IP 53 still navigating on WAN1