Configuration Question CPE 210
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configuration Question CPE 210
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
I just purchased two TPLink CPE 210 High Power Outdoor CPE/Access Points and I plan on using one or two of them to connect my shop to my home network. Below are the two configurations that I may use. The shop is on the left and is about 150 feet from the home network on the right. I will try the first one and if I have a good enough signal for the intended bandwidth with just one CPE 210 at the shop, I will use that and save some money. If it does not provide an adequate signal I will use the second one. My questions are: In Scenario 1 how do I configure the CPE 210? As an AP, Client, Repeater, AP Router, or AP Client Router? In Scenario 2, how do I configure CPE 210 (A)? As an AP, Client, Repeater, AP Router, or AP Client Router? and then how do I configure CPE 210 (B)? As an AP, Client, Repeater, AP Router, or AP Client Router? Any help in configuring each way is appreciated. I know some about networking but what I don’t know about it certainly outweighs what I do know. :p
Thanks again!
Hardware Version : Not Clear
Firmware Version :
ISP :
I just purchased two TPLink CPE 210 High Power Outdoor CPE/Access Points and I plan on using one or two of them to connect my shop to my home network. Below are the two configurations that I may use. The shop is on the left and is about 150 feet from the home network on the right. I will try the first one and if I have a good enough signal for the intended bandwidth with just one CPE 210 at the shop, I will use that and save some money. If it does not provide an adequate signal I will use the second one. My questions are: In Scenario 1 how do I configure the CPE 210? As an AP, Client, Repeater, AP Router, or AP Client Router? In Scenario 2, how do I configure CPE 210 (A)? As an AP, Client, Repeater, AP Router, or AP Client Router? and then how do I configure CPE 210 (B)? As an AP, Client, Repeater, AP Router, or AP Client Router? Any help in configuring each way is appreciated. I know some about networking but what I don’t know about it certainly outweighs what I do know. :p
Thanks again!
