Bug or cli reference wrong with new firmware
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bug or cli reference wrong with new firmware
Region : Austria
Model : TL-SG3424
Hardware Version : V1
Firmware Version : TL-SG3424_V1_140515
ISP :
Hi,
after updating 2 switches and restore config, i found there was no password restored.
Ok set the password in WebGui and save. Now am am not able to Login again, every time wrong password.
Bad but let's try it over serial.
Connction ok, than
enable
config
TL-SG3424(config)#user tplink password password type admin status enable (same as in cli guide)
TL-SG3424(config)#user tplink password password type admin status enable
------------------------------------^
Error: Invalid parameter.
So something has changed in this firmware that is the reason why the backup was not setting the password...
Who has the hint how to add a user or set the admin password in the right way.
thx markus
Model : TL-SG3424
Hardware Version : V1
Firmware Version : TL-SG3424_V1_140515
ISP :
Hi,
after updating 2 switches and restore config, i found there was no password restored.
Ok set the password in WebGui and save. Now am am not able to Login again, every time wrong password.
Bad but let's try it over serial.
Connction ok, than
enable
config
TL-SG3424(config)#user tplink password password type admin status enable (same as in cli guide)
TL-SG3424(config)#user tplink password password type admin status enable
------------------------------------^
Error: Invalid parameter.
So something has changed in this firmware that is the reason why the backup was not setting the password...
Who has the hint how to add a user or set the admin password in the right way.
thx markus