How to setup DMZ in public mode
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to setup DMZ in public mode
Region : Germany
Model : TL-ER6020
Hardware Version : V1
Firmware Version : 1.0.1 Build 20130618 Rel.46227
ISP :
Hi all,
I'm trying to setup a DMZ in public mode - so that there is a host in the dmz with a public static address. I read the manual several times - but I don't know what to do.
What I've done so far:
-enable DMZ
-set mode to public
What must I enter for the IP-address? Public IP-Adress? Do I need 3 public IP-Adresses (1 for WAN, 1 for DMZ, 1 for host in DMZ)?
I can get up to 5 IP-Adresses from my provider. Right now I have 2 - but if I try to enter the second one for the DMZ - there is an error message regarding a subnet conflict with some other port (probably WAN-Port).
All public IP-Adresses are bound to MAC adresses - is this a problem?
Can you please help me?
Regards,
Andreas
Model : TL-ER6020
Hardware Version : V1
Firmware Version : 1.0.1 Build 20130618 Rel.46227
ISP :
Hi all,
I'm trying to setup a DMZ in public mode - so that there is a host in the dmz with a public static address. I read the manual several times - but I don't know what to do.
What I've done so far:
-enable DMZ
-set mode to public
What must I enter for the IP-address? Public IP-Adress? Do I need 3 public IP-Adresses (1 for WAN, 1 for DMZ, 1 for host in DMZ)?
I can get up to 5 IP-Adresses from my provider. Right now I have 2 - but if I try to enter the second one for the DMZ - there is an error message regarding a subnet conflict with some other port (probably WAN-Port).
All public IP-Adresses are bound to MAC adresses - is this a problem?
Can you please help me?
Regards,
Andreas