EAP235-Wall:: Config VLAN to ETH port different from AP's
Hi,
Network hardware:
1.28PORT switch- SG2428P v5.20
2.Router- ER605 v2.0
3. Hardware Controller - OC200
4. AP - 3X EAP235-Wall(US) v1.0
5. AP - 2X EAP265 HD(EU) v1.0
VLANs:
1. VLAN_1 - 192.168.0.x is Infrastructure (AP's Switches and so on)
2. VLAN_10 - 192.168.10.x is PC ( where all known PCs are connected)
3. VLAN_20 - CAMs
4. VLAN_30 - IOTs
In my office an Eth cable connected from port 10 of the switch to EAP235 192.168.0.8 ( VLAN_1 and IP was defined successfully).
On port Eth3 of EAP235, a PC is connected and should be connected to VLAN_10 and have a static IP of 192.168.10.14, but no mather what I did it gets 192.168.0.9.
I have many other clients, wired and wireless connected to network and assigned VLANs properly, including a Proxmox server that share all VLANs to VMs successfully.
This is the first instance of connecting a wired PC from an AP, while assigning VLAN fails.
Please help :)
Hi @guyd2,
I'm not sure if the 235 Wall works like the 615 Wall, but on my 615 Wall (latest firmware) I'm able to assign port profiles on the APs ports just like a switch. I think the default would be to use the native vlan on the switch where the AP is connected which I think is what you're seeing.
Hi @guyd2,
I'm not sure if the 235 Wall works like the 615 Wall, but on my 615 Wall (latest firmware) I'm able to assign port profiles on the APs ports just like a switch. I think the default would be to use the native vlan on the switch where the AP is connected which I think is what you're seeing.
