Additional information:

In the Details Tab of the Device/Downlink it shows an EAP downstream.  However, in the Mesh Tab (had to temporarily turn on Mesh to see info) of the Device it says "No Entry in Table".  Seems to be a bug...?

Also, all EAPs say Uplink (wired)...

  @Vincent-TP They are all connected to a TL-SG1005P (to get PoE) behind the main switch that is a TL-SG2218.  Thanks!!

  @Vincent-TP Seemed to work for about a minute after rebooting (all EAP's were shown at the root level).  However after this they whent back to the cascade format...  Below is after rebooting and waiting for a few minutes.

  @Aveamantium 

If you have a non-Omda switch in your network, something like this will happen. You won't get a proper map, sometimes the network will split up completely, so I recommend you replace the TL-SG1005P with a SG2008P if you are concerned about the map being correct.

Here is an example of what can happen when there is a non-Omada switch between the router and access point.