Hi @d0ugmac1 

Thanks for your valued reply.

@dunxd 

Please try to set the SSID without 6GHz, change the WPA mode to WPA/WAP2-PSK not includes WPA3 so that the PMF can be disabled. The 3.2.2 of EAP235-Wall has added the support of PMF.

dunxd wrote

  @Hank21 I have done as you suggested.

 

Disabled 6 MHz on the SSID

Set the authentication to WPA2-PSK/AES

This switches PMF to disabled.

 

Then upgraded the EAP235-wall to 3.2.2

Then rebooted the EAP234-wall.

 

This has not made any improvement - the web is unusable for clients on 3.2.2.

Hi @dunxd 

May I confirm what kind of devices you have tried?

To assist you better, I've created a support ticket via your registered email address, and escalated it to our support engineer to look into the issue. The ticket ID TKID240539202, please check your email box and ensure the support email is well received. Thanks!

Once the issue is addressed or resolved, welcome to update this topic thread with your solution to help others who may encounter the same issue as you did.
 

js39a wrote

  @dunxd -

Yes had the same experience.

 

Setup:

Omada Controller Version: 5.13.22

Internet Connection: 1 Gbit/s down/ 280 Mbit/s up.

• All my EAP 235 are : EAP235-Wall(EU) v1.0
• 3 Outdoor AP's EAP225-Outdoor(EU) v1.0 powered via POE from 3 of these EAP 235
• all EAP's powered through POE from a TL-SG2428P v1.0 (Firmware 1.1.10)
• Flat Network, No VLAN, so no extra settings (gave up on it as it broke too often)

 

 

Rolling Upgrade via Omada Controller - then hell broke loose.

 

Was crazy to "debug":

 

     Oookla Speedtest showed "full speed",

      Business VPN worked flawlessly

      but Netflix, Amazon Prime, MagentaTV all failed

      Not even Amazon Website was "reachable"

 

The issue was only on "WIFI" (independent of 2.4 or 5 Ghz)

 

Clients on EAP235 (Firmware 3.2.2) affected, clients on Outdoor 225 (Firmware 5.1.6) unaffected.

Speedtest on some clients (all with full signal: 866 on both TX/RX, SNR > 50 dB) showed that "upload" is affected: Speedtest download > 500 MBit/s whilst upload <10MBit/s

Connecting the same clients via Ethernet : no issues.

 

Rolling back to 3.1.1 fixed the WIFI issues (same client as above : 594Mbit/s down / 263Mbit/s up)

 

hope that helps
 

 

Hi @js39a 

May I confirm whether you have tried to disable the 6GHz, set the WPA mode not contains WPA3 and disable the PMF? 

If rather, I've created a support ticket via your registered email address, and escalated it to our support engineer to look into the issue. The ticket ID TKID240539216, please check your email box and ensure the support email is well received. Thanks!