Business Community > All Threads > Open port between VLAN's
< All Threads

Open port between VLAN's

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Open port between VLAN's

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Open port between VLAN's
Open port between VLAN's
2024-05-05 03:35:32
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version: 2.2.4 Build 20240119 Rel.44368

I have an OC200 controller and an ER605 router. I would like to set up a rule to allow any devices in VLAN 10 to access a specific device in VLAN 20 over a specific port. Can someone give me an example of what router rule I would need to set up and what would I put in it?

  0      
 
  0      
 
#1
Options
1 Reply
Re:Open port between VLAN's
2024-05-05 17:27:29

  @Entirelynutz 

 

Do you have an Omada-controlled switch in your setup?  If not, it cannot be done with just the ER605.  The SG2008 is the entry level Omada switch that will allow you do create IP specific ACLs.

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 305

Replies: 1

Related Articles
Port forwarding, Open NAT, XBOX
1240 0
ER605 port 443 open shields up test
937 0
Port profiles not appearing in Cloud Controller to assign VLAN's to specific port
324 0
Port 80 open externally with config page on TL-R605
2903 0
Open VPN
837 1
Open VPN - No routing
4219 1
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.