Business Community > All Threads > OC300 LAN ports LAG trunking?
< All Threads
 
0
Votes

OC300 LAN ports LAG trunking?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
 
0
Votes

OC300 LAN ports LAG trunking?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
OC300 LAN ports LAG trunking?
OC300 LAN ports LAG trunking?
2024-03-28 02:49:06 - last edited 2024-06-10 14:57:03

The OC300 Omada controller has two 1000Base-T LAN interfaces on the controller unit. Is it possible to set the ports on the OC300 itself into LAG trunking mode? Otherwise, the second port will sit idle due to loopback protection on my switch.

 

I think the same functionality would also be useful on the new OC400 controller, which also has multiple LAN interfaces. Thanks!

#1
Options
1 Accepted Solution
Re:OC300 LAN ports LAG trunking?-Solution
2024-03-29 07:40:44 - last edited 2024-06-10 14:57:03

 

tk1kt wrote

The OC300 Omada controller has two 1000Base-T LAN interfaces on the controller unit. Is it possible to set the ports on the OC300 itself into LAG trunking mode? Otherwise, the second port will sit idle due to loopback protection on my switch.

 

I think the same functionality would also be useful on the new OC400 controller, which also has multiple LAN interfaces. Thanks!

Hi @tk1kt 

The OC300 does not support this feature on its hardware currently. But I will mark down your request and forward to the developer team.

 

Besides, you may also try to set the STP redundancy on the switch to achieve that.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
#2
Options
1 Reply
Re:OC300 LAN ports LAG trunking?-Solution
2024-03-29 07:40:44 - last edited 2024-06-10 14:57:03

 

tk1kt wrote

The OC300 Omada controller has two 1000Base-T LAN interfaces on the controller unit. Is it possible to set the ports on the OC300 itself into LAG trunking mode? Otherwise, the second port will sit idle due to loopback protection on my switch.

 

I think the same functionality would also be useful on the new OC400 controller, which also has multiple LAN interfaces. Thanks!

Hi @tk1kt 

The OC300 does not support this feature on its hardware currently. But I will mark down your request and forward to the developer team.

 

Besides, you may also try to set the STP redundancy on the switch to achieve that.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
#2
Options

Information

Helpful: 0

Views: 605

Replies: 1

Voters 0

No one has voted for it yet.

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.