EAP230-Wall - When it's getting advanced features ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP230-Wall - When it's getting advanced features ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP230-Wall - When it's getting advanced features ?
EAP230-Wall - When it's getting advanced features ?
2024-02-18 10:14:12 - last edited 2024-02-28 07:30:09
Model: EAP230-Wall  
Hardware Version: V1
Firmware Version: 3.1.1

When is this AP getting advanced features like its siblings ?

 

Even EAP115-Wall has this feature of advanced data

 

I am using latest beta

 

Like showing advanced data about utilization of channels like this:

 

 

This is currently showing, this is not enough:

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:EAP230-Wall - When it's getting advanced features ?-Solution
2024-02-19 08:58:54 - last edited 2024-02-28 07:30:09

Hi @pdu_,

 

Due to chip differences, the channel utilization on the EAP230-Wall cannot distinguish Tx/Rx frame, so Tx/Rx and Interference are uniformly represented by Busy.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:EAP230-Wall - When it's getting advanced features ?-Solution
2024-02-19 08:58:54 - last edited 2024-02-28 07:30:09

Hi @pdu_,

 

Due to chip differences, the channel utilization on the EAP230-Wall cannot distinguish Tx/Rx frame, so Tx/Rx and Interference are uniformly represented by Busy.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options