Hello,

I'm encountering a potential issue with the Omada Software Controller (version 5.13.23)

and the ER605 V2.0 router (firmware version 2.2.3 Build 20231201 Rel.32918) in a dual WAN setup.

I would appreciate any insights or solutions from the community.

Background:

I have two WAN connections. My objective is to configure my desktop computer to use the backup WAN (WAN/LAN1)

for HTTP and HTTPS traffic due to random timeouts experienced while browsing and building Docker images.

These timeouts are not noticeable during streaming or other activities.

I suspect an issue with my primary ISP, as these timeouts do not occur with a different ISP.

Current Configuration:

• Load Balancing Settings:

  • Application Optimized Routing: Enabled
  • Link Backup: Enabled
  • Primary WAN: WAN
  • Backup WAN: WAN/LAN1
  • Backup Mode: Always Link Primary
  • Mode: Enable backup link when all primary WANs fail

• Policy Routing Settings:

  • Protocols: All
  • WAN: WAN/LAN1
  • Source: IP Group containing my computer's IP
  • Destination: IP-Port-Group with any 80 and 443

Issue:

• When the option "Use the other WAN port if the current one is down" is disabled, my desktop correctly uses the Backup WAN/LAN1.
• However, enabling this option results in my desktop only using the Primary WAN, contrary to my configuration.

I suspect this might be a bug, or perhaps there's an aspect of the UI that is not clearly explained.

The system setup is only a day old, and no other significant configurations have been made.

Has anyone else experienced this issue, or can anyone provide guidance on whether this is a bug or a configuration error on my part?

Thank you for your assistance.

Steve