Vlan Issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Vlan Issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Vlan Issue
Vlan Issue
2024-01-05 12:11:30 - last edited 2024-01-05 23:32:06
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version:

 I have a problem with VLANs. Everything was fine but I tried to switch one device to a new VLAN, and it started a problem. I removed all VLANs and ACLs, but with one new VLAN result is the same.

I can't ping between devices on a wire.

I use:

 

I've made new VLAN:

 

when I connect the first laptop with static ip 192.168.20.2 255.255.255.0 gateway 192.168.20.1 to the port with all profiles I have internet access and I can ping devices from the main network eg 192.158.0.151(second laptop). From the second laptop I'm able to ping 192.168.20.1 but when i ping 192.168.20.2 i receive Reply from 192.168.0.1: Destination host unreachable.

If I remember well without ACL communication between VLANs should be open.

I also tried with some ACLs to permit access but without any success.

Any idea what should I change?

  0      
  0      
#1
Options
1 Accepted Solution
Re:Vlan Issue-Solution
2024-01-05 16:47:30 - last edited 2024-01-05 23:32:06

  @michalmit 

 

The TAG itself doesn't completely relay to the Windows Laptop unless the NIC configs have the tag set. 

 

You will need to trunk that port to VLAN 2 for your laptop to be completely on that VLAN.  

 

 

I can not teach anyone anything - I can only make them think - Socrates
Recommended Solution
  0  
  0  
#2
Options
3 Reply
Re:Vlan Issue-Solution
2024-01-05 16:47:30 - last edited 2024-01-05 23:32:06

  @michalmit 

 

The TAG itself doesn't completely relay to the Windows Laptop unless the NIC configs have the tag set. 

 

You will need to trunk that port to VLAN 2 for your laptop to be completely on that VLAN.  

 

 

I can not teach anyone anything - I can only make them think - Socrates
Recommended Solution
  0  
  0  
#2
Options
Re:Vlan Issue
2024-01-05 17:18:19
Yes, I've done it and it's working. Now I don't know how to tag port with proxmox server where I have a VM with Omana Controler which I want to have in VLAN1, and VM with Home Assistant which I want in VLAN2?
  0  
  0  
#3
Options
Re:Vlan Issue
2024-01-08 11:49:46

  @michalmit 

 

its been a while since I messed with proxmox.  I'm a VMware dude.

 

in general u will need to configure a another virtual nic with the vlan tag of 2 and assign it to the vm.

 

I can not teach anyone anything - I can only make them think - Socrates
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 457

Replies: 3

Related Articles