I am expanding my outdoor network and spent all day today trying to connect 2 CPE210 together using ethernet ports unsuccessfully.  Here is my goal.  I have a router in my house.  I have a CPE210 running off solar about 300 feet from my house.  I would like the first CPE210 to pick up the signal from my router in my house.  I would like that CPE210 to then pass that signal over an ethernet cable to a second CPE210 that is mounted on the same post as the first CPE210.  I would like the second CPE210 to then send the signal all the way down my driveway.  My drive way has a corner and the property is heavily wooded.  Basically I am trying to send the WIFI signal down around a corner to the end of my drive way.  Currently I have one CPE210 acting as a repeater but the signal to my house is week.  I was looking to have a second CPE210 pointed right at my house to increase the signal strength.  Would anyone be able to give a little input on how to get this to work?  Which modes to be running both CPEs in?  I would like to do it in a way that impacts the throughout the least.