Home

Forums

Stories

Knowledge Base

Business Community > All Threads > Export settings from Switch/Gateway to Omada Software Controller

< All Threads

Export settings from Switch/Gateway to Omada Software Controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Export settings from Switch/Gateway to Omada Software Controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CheGuevara

2023-07-25 13:49:04 - last edited 2023-07-27 02:06:00

Posts: 4

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-09-19

Export settings from Switch/Gateway to Omada Software Controller

2023-07-25 13:49:04 - last edited 2023-07-27 02:06:00

Tags: #Adoption #Controller Installation

Actually the question - is it possible to export settings from Switch/Gateway, configured in stadnalone mode, to Omada Software Controller??? I have fully configured TL-SG3428X and ER605 in standalone mode and I want add this switch to Omada and don't loose settings

1 Accepted Solution

Hank21

2023-07-26 03:47:26 - last edited 2023-07-27 02:06:00

Posts: 3673

Helpful: 718

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:Export settings from Switch/Gateway to Omada Software Controller-Solution

2023-07-26 03:47:26 - last edited 2023-07-27 02:06:00

Hello @CheGuevara,

All settings you have set in standalone mode will be erased once the devices are managed by the controller.

You may pre-configure all settings on the controller first and adopt the router and the switch, the controller will assign the settings to devices automatically.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

Recommended Solution

1 Reply

Hank21

2023-07-26 03:47:26 - last edited 2023-07-27 02:06:00

Posts: 3673

Helpful: 718

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:Export settings from Switch/Gateway to Omada Software Controller-Solution

2023-07-26 03:47:26 - last edited 2023-07-27 02:06:00

Hello @CheGuevara,

All settings you have set in standalone mode will be erased once the devices are managed by the controller.

You may pre-configure all settings on the controller first and adopt the router and the switch, the controller will assign the settings to devices automatically.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

Information

Helpful: 0

Replies: 1

Export settings from Switch/Gateway to Omada Software Controller

Export settings from Switch/Gateway to Omada Software Controller

Information

Voters 0

Tags