TL-SG3452X snmp monitoring in Zabbix 6.0 LTS
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I configured this switch in Zabbix using the Zabbix supplied Template "TP-LINK SNMP".
This works but the values seem incorrect.
Eg one of the 10Gb ports I see max traffic of 150Mbps in Zabbix while I see 1.5Gb in the oc200 statistics at the same time.
I did not install the tp-link mib files on my Zabbix host. Should I have done this and if so all?
Hi,
This is the TP-Link snmp template
On a typical day on interface 51 (10Gb) is now see the following traffic
I manually created an SNMP template to monitor the same switch. No I do see correct values.
It's not the same day but normally we would see a big spike at 17:00 because backups start.
I think the problem is in the TP-LINK template supplied by Zabbix (6.0 LTS) but can work with the self created setup I now have.
I use latest OC200 firmware.
Topology is pretty simple. 3 ESX servers and a Synology NAS connected to the 10Gb ports, rest of the clients to the 1Gb ports. 2 VLANs (one guest for Wifi and some assigned (untagged) ports).