Business Community > All Threads > Failover backup does not work?
< All Threads

Failover backup does not work?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Failover backup does not work?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Failover backup does not work?
Failover backup does not work?
2023-03-03 09:07:52
Tags: #failover
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.2.2

I have two ISPs - one connected to WAN and the other to WAN/LAN1. Today, I found that I'm offline. The controller (5.9.9) showed both WANs as online. The online detection method is set to ping. Both WANs are connected using a dynamic IP. What could be wrong? Logs say nothing about it (no warning, event, just nothing).

 

 

  0      
 
  0      
 
#1
Options
4 Reply
Re:Failover backup does not work?
2023-03-03 11:41:27

  @ZdenekM Your WAN DNS server is:

 

But WAN/LAN1 is:

 

Why???

  0  
  0  
#2
Options
Re:Failover backup does not work?
2023-03-03 12:08:16

  @HelsingL Good catch, thanks. That was a mistake. However, it should not influence anything - online detection is based on pinging an IP address and there is set the (correct) DNS server in DHCP server configuration.

  0  
  0  
#3
Options
Re:Failover backup does not work?
2023-03-03 14:04:02

  @ZdenekM 

 

How does your online detection config look like?

Asking as your printscreen shows echo server 8.8.8.8 wich is being used for latency measunring and not for online detection...

In router standalone mode it looks like this (defaults):

 

  0  
  0  
#4
Options
Re:Failover backup does not work?
2023-03-04 09:12:57

Hi  @ZdenekM 

 

Have you tried to run a continues ping test on your PC? (like ping 8.8.8.8 -t)

 

In normal case a double NAT could slow down the Online detection because your WAN default gateway will always reply the ping. But in normal case it won't take so long since the router can not get a reply from echo server(8.8.8.8 you set up). 

 

I suspect the Internet is actually still online, but there are some problem on upload/download speed that makes you feel the Intenret is "offline". 

 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 711

Replies: 4

Tags

failover
Related Articles
failover link backup
1155 0
Failover backup time
2986 0
Configuring failover to backup WAN
397 0
Failover / Link Backup not working for IPv6?
666 0
Does MR400 work with ER605 on one of the WAN ports as Backup
396 0
Er605: failover too slow
913 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.