Connecting a Card Access network to a remote Card Access Controller using CPE510

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Connecting a Card Access network to a remote Card Access Controller using CPE510

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Connecting a Card Access network to a remote Card Access Controller using CPE510
Connecting a Card Access network to a remote Card Access Controller using CPE510
2023-02-08 10:26:10 - last edited 2023-02-09 02:25:19

In trying to connect an existing Card Access Network to a remote Card Controller using (2) CPE510 devices, we are using the AP and Client modes.

Should we be using the Bridge mode instead?

  0      
  0      
#1
Options
1 Reply
Re:Connecting a Card Access network to a remote Card Access Controller using CPE510
2023-02-09 02:28:03

Dear  @IconPoc 

 

In normal case we don't use bridge mode. 

AP-Client mode is the best solution for point-to-point connection. 

 

How to build a Wireless Network between home and farm using tp-link products

 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options