@TandS 

 

I haven't found any problems with my WLAN Schedule so far.
Did this function start working reliably after the upgrade?
Does it work properly if you reset it once?
Are there regular times when it doesn't work?

  @Virgo 

I have it set to turn off every wifi radio from Sunday - Thursday from 700pm - 930pm.

 

As an example, It didn't work this past Sunday or Monday but worked last night.  

 

Not sure what you mean by reset it ? I have power cycled all devices since implementing the schedule (which I only started using approx. 3 weeks ago).  The firmware on all devices haven't changed since being implemented (albeit I went from the router 9022 beta to the 1015 beta but revert back to 9022 on the same day).  

 

I wasn't keeping track of when it wasn't working in the beginning as I went through the usual troubleshooting steps (including checking the date / time on controller and router) but each week there was at least one day it didn't work. 

 

  @TandS 

 

It is likely that something has triggered the controller to not send the full configuration, try forget EAP, re-adopt EAP and test again.

  @Virgo 

Thanks for the suggestion.  I will try that next time the issue occurs.

It worked again last night so I'm afraid to play with it right now.  

It would be nice if TP-Link could point me to logs I might be able to look at for clues.  There are no errors or warnings showing up in the controller logs.

 

 

Knock on wood.... it's been working as expected since my last posting.

 

I ugpraded to linux omada controller 5.7.4 yesterday and rebooted all equipment after the upgrade.

 

I'll post a reply if the issue manifests again.

 

Spoke to soon....

It didn't work again today.

 

Sigh 😔

Dear @TandS ，

 

Thank you so much for taking the time to post the issue on TP-Link community!

 

To better assist you, I've created a support ticket via your registered email address, and escalated it to our support engineer to look into the issue. 

The ticket ID is TKID221137546, please check your email box and ensure the support email is well received. Thanks!

Once the issue is addressed or resolved, welcome to update this topic thread with your solution to help others who may encounter the same issue as you did.

 

Many thanks for your great cooperation and patience!

With further testing it appears as though the settings don't always get applied. IE: If I pick a time range and apply it, it will say Succeeded but it I don't think it necessarily applied them. I tried hitting apply a few times, changing to a different set of ranges, clicking apply and then setting back to original time range and clicking number a few times and eventually it seems to stick. But you don't know if it correctly applied until the time comes.