Business Community > All Threads > EAP 245 stops working after a while for a few hours after config change
< All Threads

EAP 245 stops working after a while for a few hours after config change

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP 245 stops working after a while for a few hours after config change

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP 245 stops working after a while for a few hours after config change
EAP 245 stops working after a while for a few hours after config change
2022-10-03 14:33:37
Model: EAP245  
Hardware Version: V3
Firmware Version: 5.0.4

Hello ! Recently I noticed that a device is not switching to 2G with a better connection from weak 5G, so I raised the signal of 5G from "medium" to "high". Now, it seems like it stopped working after a while, then started working again after a few hours. I'm wondering if I should have restarted it ?

  0      
 
  0      
 
#1
Options
1 Reply
Re:EAP 245 stops working after a while for a few hours after config change
2022-10-10 10:55:02

  @doremifajb 

 

It may be because the EAP detected the radar signal after you changed the EAP's Tx power and triggered the DFS mechanism.

Just striving to develop myself while helping others.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 410

Replies: 1

Related Articles
EAP 245
774 0
EAP 245 can't update firmware
1140 0
EAP 245 v3 Firmware 5.0.6
8880 0
Upper 5GHz channels on EAP-245
7876 0
Usage of Mesh and Bridge AP with EAP 245
3873 0
Speed EAP 245
3872 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.