ER605 and ipv6 on Verizon Fios

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 and ipv6 on Verizon Fios

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER605 and ipv6 on Verizon Fios
ER605 and ipv6 on Verizon Fios
2022-09-02 13:19:20 - last edited 2022-09-06 20:18:24
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version: 2.0

Any suggestions on getting ipv6 working with the ER605 and Verizon Fios?  It was working fine w/a previous Actiontec.  I believe for WAN it is supposed to be stateless and then 56 for the prefix.  If I put those in then it will change the link to up and I'll get a gateway address, but I never get an ipv6 address and ipv6 tests fail.

  0      
  0      
#1
Options
1 Accepted Solution
Re:ER605 and ipv6 on Verizon Fios-Solution
2022-09-05 11:41:00 - last edited 2022-09-06 20:18:24

  @kes601 

 

Did you also set IPV6 on the LAN page? Lan should use the prefix obtained by wan from the ISP.
WAN IP is obtained normally, right?

Just striving to develop myself while helping others.
Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:ER605 and ipv6 on Verizon Fios-Solution
2022-09-05 11:41:00 - last edited 2022-09-06 20:18:24

  @kes601 

 

Did you also set IPV6 on the LAN page? Lan should use the prefix obtained by wan from the ISP.
WAN IP is obtained normally, right?

Just striving to develop myself while helping others.
Recommended Solution
  0  
  0  
#2
Options
Re:ER605 and ipv6 on Verizon Fios
2022-09-06 20:18:19

  @Virgo 

 

Thanks for the tip.  I think the issue was two-fold.  One was your suggestion on the LAN page and also needed to put in DHCP servers on the WAN side since I don't believe Verizon auto assigns them via DHCP.  At any rate I did those two things and works now.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 816

Replies: 2

Related Articles