Hello,

I bought this switch as, during lockdown, it became obvious that I needed ethernet cabling rather than relying on wifi. My house is cabled and, until I bought the stitch, the cables connected into the LAN ports on the back of my router.

I have followed the connection instructions to the letter. Needless to say, a device described as 'plug and play' is anything but.

I simply don't understand all the gobbldygook that passes as instructions.You need to be an IT specialist to understand the jargon, and I am a psychologist. So, no chance!

Can anyone help? I changed the IP address on the switch, however when I switch to auto DHCP it then acquires a different address to my router. There my expertise ends. I would be super grateful for some help and advice.

Regards,

Robert