The main purpose of the beta was to fix VLAN tags on the 3 ethernet ports (I still need to pull an in-service unit to test the back to back connection of 2 x EAP235-walls with multiple SSIDs, tagged and untagged) as I wasn't willing to buy any more until there was some evidence they'd continue to be supported. Regardless, through luck or fate or intent, the codebase for the 235 beta build seems more recent that the other two (I could be wrong). Those were the two big ones for me....proper VLAN behaviour and PPSK, so I'm encouraged!

  @nixcamic 

 

Ok, so I went to another more recent firmware build for another EAP (but still an earlier build than the beta for the 235) and found this feature list:

 

 

2. Appears done / 3. IS DONE! 

 

 

5. Appears done

 

.  

 

Here's the corresponding bug fix (again...not all may be applicable to the 235!, but they could be fixed if they are :). )

 

Bug Fixed:

 

1. Fixed the bug that traffic statistics are too large.

2. Fixed the bug that Controller will not send traffic log of VLAN SSID client.

3. Fixed the bug that reply to Probe Response causes SSID hiding function to fail.

4. Fixed the bug that Tx packet loss rate and error rate of about 25% under 5GHz.

5. Fixed the bug that Client Log cannot be obtained in mesh state.

6. Fixed the bug that the destId of the first Inform message after Controller migration is probabilistically wrong.

7. Fixed the bug that the SSID name with the longest character causes the content of the System log to be garbled.

8. Fixed the bug that the portal page cannot pop up and the authentication cannot be completed after entering the EAP IP address on the connected client.

9. Fixed the bug that MAC accounting does not support session timeout.

10. Fixed the bug that sometimes a blank symbol can be used in the password of the SSID in Quick Setup.

11. Fixed the bug that the roaming threshold may be lower than the minimum value when AI Roaming is enabled.

12. Fixed the bug that new user may skip the portal authentication when authorized clients number reaches maximum.

13. Fixed the bug that EAP gets different recognition results for different IP formats when setting the IP address of the RADIUS server.

  @nixcamic 

 

the current beta software should go production within a month or two:

 

 

The 3.0.99 beta code for the 235-wall supports PPSK without RADIUS.