load balance - fail over
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I am using the OC200 Omada controller. Trying to figure out the proper load-balance / failover setup.
seems to be 2 sections but unable to find clarification as all examples I can find are with persons connecting directly to the router, which is a completely different setup from when you go to the settings in the Omada controller.
nowhere I have found is explains the "load balancing weight" and how these setting can vary the used WAN port. If LBW box 1 represents WAN#1, box 2 represents WAN#2, and box 3 represents WAN#3, what number in these boxes represent priority and what is the highest value can be entered
when using "link backup" is there a option that comes up the you can select "priority" WAN #1, "Secondary WAN #2, and "Third" Wan #3. Ir is in only "priority" WAN #1, "Secondary WAN #2
any info is much appreciated
I think you're right, those three blanks would correspond to the ratio you want to set for each of the three WANs, in the case of 10, it could be 2:3:5, something like that.
In fact, the router standalone interface explains a bit more, if you really can't, you can just click Pre-populate.
