BUG - Checking for counter rollovers

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

BUG - Checking for counter rollovers

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
BUG - Checking for counter rollovers
BUG - Checking for counter rollovers
2022-05-10 13:51:58 - last edited 2022-07-29 09:16:36
Model: OC200  
Hardware Version: V1
Firmware Version: 5.1.7

A *massive* spike in packet counts this morning, it's very obviously a 32bit rollover on the packet counter, as there's no way my little switch passed 4.3 billion packets in 5min.

 

2^32 = 4294967296

 

<< Paying it forward, one juicy problem at a time... >>
  0      
  0      
#1
Options
1 Accepted Solution
Re:BUG - Checking for counter rollovers-Solution
2022-07-04 19:19:58 - last edited 2022-07-29 09:16:36

  @Hank21 

 

Beta firmware seems to have resolved the issue.  See below plot, yellow divider shows approx date the beta fw was installed on my SG2008P

 

<< Paying it forward, one juicy problem at a time... >>
Recommended Solution
  2  
  2  
#3
Options
2 Reply
Re:BUG - Checking for counter rollovers
2022-05-11 07:53:25 - last edited 2022-07-29 09:16:36

d0ugmac1 wrote

A *massive* spike in packet counts this morning, it's very obviously a 32bit rollover on the packet counter, as there's no way my little switch passed 4.3 billion packets in 5min.

 

2^32 = 4294967296

 

Dear  @d0ugmac1 

 

To assist you efficiently, I've forwarded your case to the TP-Link support team who will contact you with your registered email address later.

Please pay attention to the email box for follow-up. Thank you so much for your cooperation and patience.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:BUG - Checking for counter rollovers-Solution
2022-07-04 19:19:58 - last edited 2022-07-29 09:16:36

  @Hank21 

 

Beta firmware seems to have resolved the issue.  See below plot, yellow divider shows approx date the beta fw was installed on my SG2008P

 

<< Paying it forward, one juicy problem at a time... >>
Recommended Solution
  2  
  2  
#3
Options

Information

Helpful: 0

Views: 590

Replies: 2

Related Articles