This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Good day dear all I have TP Link L2 switch which is T2600G-28TS 4.0 now I want a port trunk and tried switchport mode trunk, switchport trunk allowed vlan 10, but these commands doesn't work, could you please write commands how it is going to be switchport mode trunk and switchport trunk allowed vlan 10
Hi @Murodjon
The vlan_trunk command is used to enable VLAN Trunk for the desired port. When enabled, all packets in VLANs will pass through this port.
For example:
Switch(config)#interface gigabitEthernet 1/0/3
Switch(config-if)#vlan_trunk
If you only want VLAN 10, then you need to set up port to “general” to VLAN 10 and its egress-rule as “tagged”
For example:
Switch(config)#interface gigabitEthernet 1/0/4
Switch(config-if)#switchport general allowed vlan 10 tagged
You may refer to the CLI guide:
https://static.tp-link.com/2020/202011/20201103/1910012904_T16_T26_CLI.pdf
Helpful: 0
Views: 1360
Replies: 1
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
